Filter
Top Products
7–Removal and Replacement
iSR6200 Chassis Blades
7-4 ISR651101-00 G
2. Insert the new blade into the chassis slot. Figure 7-4 shows how to push the
blade straight into the chassis (1), and then seat the blade onto the chassis
mid-plane by pushing up the right side lever and latching it into place (2).
The blade powers on and boots up.
Figure 7-4. Inserting the New Blade into the Chassis Slot
3. Reconnect all cables to the new blade.
Single-Blade Installation
For a single-blade configuration, you must save the configuration of the original
blade using the fru save command whenever the blade configuration changes.
You can save the configuration of the blade on a server you can later access to
use for the replacement blade. After physically replacing the blade, you can then
use the fru restore command to restore the saved configuration to the
replacement blade.
This enables the replacement blade to retain all user-configured
settings.
The following sections show how to remove and replace a failed blade in a
single-blade chassis installation:
“Removing the Failed Blade” on page 7-5
“Installing the Replacement Blade” on page 7-7
(1)
(2)