Filter
Top Products
B–Simple Network Management Protocol
SNMP Parameters
B-2 ISR651101-00 G
SNMP Parameters
You can set the SNMP properties using SANsurfer Router Manager or the CLI.
For SNMP configuration details, see the iSR6200 Router Manager User’s Guide
or the iSR6200 CLI User’s Guide.
Table B-1 describes the SNMP parameters.
Table B-1. SNMP Parameters
Parameter Description
Read community
A password that authorizes an SNMP management server to read information
from the router. This is a write-only field. The value on the router and the SNMP
management server must be the same. The read community password can be
up to 32 characters, excluding the number sign (#), semicolon (;), and comma
(,). The default is password is private.
Trap community
A password that authorizes an SNMP management server to receive traps.
This is a write-only field. The value on the router and the SNMP management
server must be the same. The trap community password can be up to 32 char-
acters, excluding the number sign (#), semicolon (;), and comma (,). The default
password is private.
System
location
Specifies the name of the router location. The name can be up to 64 characters,
excluding the number sign (#), semicolon (;), and comma (,). The default is
undefined.
System contact
Specifies the name of the person to be contacted to respond to trap events. The
name can be up to 64 characters, excluding the number sign (#), semicolon (;),
and comma (,). The default is undefined.
Authentication
traps
Enables or disables the generation of authentication traps in response to
authentication failures. The default is disabled.