Filter
Top Products
UCR-150L Robot UGR003/0900
3-6
INSTALLATION
C
ONNECTING
THE
ROBOT
WARNING: Electrical hazard
Before performing any work on this product, dis-
connect and lock out electrical power sources
to prevent injury from unexpected energization
or start-up.
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.
CAUTION: Lifting
To avoid personal injury or damage to the robot,
lift the robot using a hoist. Place the straps
around the swing shaft between the strip frame and
the base.
Use a sling to lift the robot.
Place a sling under both ends of the beam and under the
traverse arm.
Move the robot into position.
Carefully hoist the robot into position on the platen.
Secure the robot to the platen with the
supplied screws, lock washers, and flat washers.
Remove any shipping brackets
holding the arms.
1
2
3
4
P
OSITIONING
THE
ROBOT