Filter
Top Products
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial plate.
WARNING: Voltage hazard.
This equipment is powered by alternating cur-
rent, as specified on the machine serial tag and
data plate.
A properly sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the electri-
cal enclosure. Improper grounding can result in
severe personal injury and erratic machine
operation.
Always disconnect and lock out the incoming
main power source before opening the electrical
enclosure or performing non-standard operating
procedures such as routine maintenance. Only
qualified personnel should perform trou-
bleshooting procedures that require access to
the electrical enclosure while power is on.
INTRODUCTION 1-3
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by fol-
lowing the procedures outlined below and elsewhere in the
User Guide.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
UGR003/0900 UCR-150L Robot