Hitachi CONVENTION 14 Welding System User Manual


 
R
Ratings label 1–4
Reactance A–6
Read/write copy unit 1–3
Rectifier A–6
Reduced torque 3–16
Regenerative braking A–6
Regulation A–6
Regulatory agency approvals 1–4
Relay
alarm signal contacts 4–44
as intelligent output 4–37
Remote control 4–27
Reset function 3–62, 4–23
Restart Mode configuration 3–42
Reverse run command 4–11
Reverse torque A–6
Revision history xviii
RF noise filter 5–4
RJ-45 modular connector 2–4, B–3
Rotor A–6
RPM 2–35
Run command 4–11
Run command source setting 2–30, 3–10, 4–29,
4-31
Run mode 2–34, 3–5
Run signal 4–37
Running the motor 2–34
Run-time edits 3–5, 3–36, 4–21
S
Safety messages i
Saturation voltage A–6
Scaling 3–40
S-curve accel/decel 3–27
Second accel and decel 3–25
Second motor 4–16
Second stage output 4–47
Sensorless vector control A-6
Serial port B–3
Service, warranty 6–16
Set 2nd motor 4–16, 4–60
Setpoint A–7
Single-phase power A–7
Sink/source input configuration 4–8
Slip
definition A–7
Software lock 3–5, 3–36, 4–21
Source/sink input configuration 4–8
Spare parts 6–11
Specifications
control logic signals 1–11, 4–6
general 1–10
inverter 1–5
inverter label 1–4
Speed control 1–19, 1–23, 4–12
Speed pot 2–26
Squirrel cage A–7
Standard functions 3–10
Start frequency 3–40
Stator A–7
Stop command 4–11
Stop Mode configuration 3–42
Supply wiring 2–19
Switches, configuration 2–5
Switching frequency 3–40
Symbol definitions i
System description 2–7
Index5
Index
5