Filter
Top Products
Keypad Operation 4-3MN1854
+
Selects the motion direction in program editor. May also be used in math
programs or equations.
u=O"
Cursor control keys that are used to scroll through menu choices in the editor.
Moves an axis in JOG mode.
Decimal Point
Used when entering fixed–point numbers.
Comma
Used in multi–axis programs to separate axis command parameters. Part of the
syntax in message and variable “prompt” commands.
Alpha
In the editor, allows entering alpha characters for the keypad.
ENTER
In the program editor, press ENTER to save parameters that have been typed.
Enters a space in the program editor mode.
Run Menu Pressing the RUN key displays a set of sub–menus.
PROG Access the sub–menus by pressing F1 (PROG), F2 (JOG), or F3 (TEST).
Action
Display Comments
Press RUN key
RUN
PROG JOG TEST
Select a sub–menu, press F1 (PROG),
F2 (JOG), or F3 (TEST).
Press F1 (PROG) to run (or
execute) an existing program
number.
OR
↑RUN PROGRAM↓
>5
Use the numeric keys to enter a
program number to run (example, 5 and
press ENTER).
Press F1 (PROG) select an
existing program to run.
↑RUN PROGRAM↓
>12 GRIND
Use the keys to scroll through the list
of programs. Press ENTER to select
the program.
JOG Pressing the RUN key displays a set of sub–menus. Press F2 (JOG).
Action
Display Comments
Press RUN key
RUN
PROG JOG TEST
Press F2 (JOG) to JOG the
motor.
OR
JOG AXIS 1 +0.0000
<LO> HIGH
Use the ←↑↓→ keys to JOG the motor.
Press F1 <LO> or F2 HIGH speed.
Use the 0–9 keys to enter the
desired JOG distance.
JOG AXIS 1 +0.0000
Dist: .012
Press and release an arrow key to
make the motor move this distance.
The arrow pressed determines the
direction of the move. Press and
release an arrow key to move the motor
again. Press ESC to terminate JOG.
Note: Jog speed and acceleration are changed in the “EDIT, SETUP, JOG” menu.