Filter
Top Products
4-6 Keypad Operation MN1854
Example of entering a program using the 0–9 keys. To create a program with the
commands “AC.3 VE2 DI1 GO”, do the following steps: (you must be in the
program editor, this example is writing to program #2).
1. Press EDIT→F1→2→ENTER to get to the first line of program 2.
2. Press F2, then press the #2 key. This will enter the AC command.
3. Press the decimal key.
4. Press the #3 key.
5. Press ENTER. This will insert a space after the 3 to separate the
commands.
6. Press F1, then press the #2 key. This will enter the VE command.
7. Press the #2 key.
8. Press ENTER. This will insert a space after the 2 to separate the
commands.
9. Press F2, then press the #1 key. This will enter the DI command.
10. Press the #1 key.
11. Press ENTER. This will insert a space after the 1 to separate the
commands.
12. Press F1.
13. Press the #3 key. This will enter the GO command.
14. Press ENTER.
15. The display should now show the program “AC.3 VE2 DI1 GO”.
Save the program
When you have completed the program, and the display shows the program
“AC.3 VE2 DI1 GO”, do the following:
1. Press ESC, the menu of Figure 4-4 is then displayed.
2. Press F1 (YES) or F3 (NO).
Figure 4-4
Save Program?
Yes No
Edit an existing program
1. Press “EDIT, F1 (PROG)” and you will see a display with a blinking
cursor as shown in Figure 4-5. Enter the name of the program you wish
to edit or scroll the list to locate the program.
Remember, ENTER inserts a space (delimiter). DEL deletes a character.
Use the cursor keys to scroll through the program one line at a time.
Figure 4-5
–↑EDIT PROGRAM↓–
>_