Filter
Top Products
Keypad Programming 6-15MN1854
Value: 0
Units: N/A
Range: N/A
Causes all commands between LP and EB to be repeated “i” times. If LP is entered without a number
following it or a 0, the loop will repeat continuously.
Note: An End of Block (EB) command must be used with every LP command.
Up to 16 nested loops (one inside the other) are allowed. Each LP command must have a corresponding EB
command to end the block (loop). A GT command within a loop will terminate the loop, clear the loop stack
and jump to a new program.
Example:
AC.09 DE.09 LP
3 VE30 DI1 GO EB VE7 DI–3 GO EN
The motor will perform an incremental 1 unit move at speed 30 three times and then a 3 unit move at speed
7 in the other direction.
LP
Loop
syntax – LPi