February 2001
VILTER MANUFACTURING CORPORATION
SECTION 100-R
Replaces
PAGE 1
May 1985
450XL
®
* VMC COMPRESSORS
REPLACEMENT PARTS LIST
(Note: Except where noted in the description column,
part listed apply to all 450XL High Stage, Booster, and
Two-Stage Compressors.)
TABLE OF CONTENTS
PAGE
1 REPLACEMENT PARTS ORDERING INSTRUCTIONS
BASIC FRAME REPLACEMENT PARTS
2 Illustration, 2 Cylinder (Figure 1)
3 Illustration, 4, 6 & 8 Cylinder (Figure 2)
4 Illustration, 12 & 16 Cylinder (Figure 3)
5 Parts List
DISCHARGE/SUCTION GAUGE
9 Illustration (Figure 4)
10 Parts List
CRANKSHAFT AND FRONT BEARING COVER REPLACEMENT PARTS
9 Illustration (Figure 5)
10 Parts List
REAR BEARING COVER REPLACEMENT PARTS
12 Illustration (Figure 6)
13 Parts List
CYLINDER LINER AND CAPACITY CONTROL REPLACEMENT PARTS
14 Illustration (Figure 7)
15 Parts List
PISTON AND CONNECTING ROD ASSEMBLY AND SAFETY HEAD REPLACEMENT PARTS
16 Illustration (Figure 8)
17 Parts List
18 RECOMMENDED SPARE PARTS LIST
REPLACEMENT PARTS ORDERING INSTRUCTIONS
1. Give the size, voltage, original order number and serial number of the compressor. All of this information is
stamped on the nameplate attached to the compressor frame. The serial number is also stamped on the
compressor frame. The compressor frame serial number location is directly above the suction flange on the
frame of the compressor or directly above the rear bearing cover. The rear bearing is located on the oil
pump/filter end of the compressor.
2. Always give the name of the part as well as the corresponding part number and/or item number. Also
include the quantity of parts required.
3. Should there be a doubt regarding the part number or name, send a sketch of the part required or return the
old part as a sample, transportation charges prepaid. Orders on which part numbers and description do not
agree will be filled according to our best interpretation.
4. All prices are F.O.B. factory. Minimum domestic parts order is $75.00 net price.
5. Please indicate on the order preferred method of shipment. We will follow your instructions unless it is to
your best interest to change routing.
6. If you purchased the compressor from a party other than Vilter Manufacturing Corporation, please state
when you purchased the compressor and from whom.
* Patents Pending
VILTER MANUFACTURING CORPORATION
PRINTED IN U.S.A.