Honeywell MX3Plus Saw User Manual


 
Subsequent Use
Note: Taskbar and Bluetooth device Icon states change as Bluetooth devices are discovered, paired, connected and
disconnected. A taskbar Bluetooth icon with a red background indicates Bluetooth is active and not paired with any
device. A device icon with a red background indicates a disconnected paired device.
1. Tap the Bluetooth icon in the taskbar or on the desktop to open the Bluetooth LXEZ Pairing application.
2. Tap the Bluetooth Devices tab.
3. Tap the Discover button. When the Bluetooth module begins searching for in-range Bluetooth devices, the button name
changes to Stop. Tap the Stop button to cancel the Discover function at any time.
4. The discovered devices are listed in the Bluetooth Devices window.
5. Highlight a Bluetooth device in the Discovered window and double-tap to open the device properties menu.
6. Tap Pair as Scanner to set up the MX3Plus to receive scanner data.
7. Tap Pair as Printer to set up the MX3Plus to send data to the printer.
8. Tap Serial Device (when Filtered mode is disabled) to set the MX3Plus to communicate with a Bluetooth serial device.
9. Tap HIDDevice to pair a HID device.
10. Tap PAN Device to pair a PAN device.
11. Tap DUN Device to pair a DUN device.
12. Tap Disconnect to stop pairing with the device. Once disconnected, tap Delete to remove the device name and data
from the Bluetooth Devices list. The device is deleted from the list after the OK button is clicked.
13. Upon successful pairing, the selected device may react to indicate a successful connection. The reaction may be an
audio signal from the device, flashing LED on the device, or a dialog box is placed on the MX3Plus display.
14. Whenever the MX3Plus is turned On, all previously paired, live, Bluetooth devices in the vicinity are paired, one at a
time, with the MX3Plus. If the devices cannot connect to the MX3Plus before the re-connect timeout time period expires
(default is approximately 20 seconds for each paired device) there is no indication of the continuing disconnect state if
Report Failure to Reconnect is disabled.
4-67