Filter
Top Products
WPA/LEAP
To use WPA/LEAP, make sure the following profile options are used.
l Enter the SSID of the Access Point assigned to this profile
l Set EAP Type to LEAP
l Set Encryption to WPA TKIP
l Set Auth Type as follows:
l If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to
Open.
l If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared.
l If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.
To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for encryption and complete other entries as
detailed in this section.
See Sign-On vs. Stored Credentials for information on entering credentials.
6-32