Filter
Top Products
Using Remote Management
For Your MX3Plus
1. Configure the radio to connect to the network running the Mobile Device Server. After the MX3Plus is connected,
proceed to step 2.
2. If it is desired to configure the radio using the Summit package, add the configured package to the Wavelink Avalanche
MC Console and enable it.
3. Verify RMU.CE.CAB exists in the \System\RMU folder.
4. Double click the MX3Plus enabler CAB file in the \System folder.
5. The enabler automatically launches after installation and contacts the Mobile Device Server. The Avalanche MC
Console connected to that Mobile Device Server identifies the remote device and performs a sync. This downloads any
available packages available for the MX3Plus.
Using eXpress Scan
eXpress Scan Desktop Icon
If the MX3Plus has an eXpress Scan icon on the desktop, eXpress Scan may be used for the initial configuration of the device.
If the eXpress Scan icon is not present on the desktop, install the Enabler following the instructions earlier in this section. If the
icon is still not present, the Enabler must be updated as detailed in the installation instructions earlier in this section.
If the eXpress Scan icon is present, follow these steps to configure the MX3Plus to connect with the wireless network and the
Mobile Device Server.
Step 1: Create Bar Codes
Bar codes are created with the eXpress Config utility on the desktop/laptop computer, not the mobile device. Depending on the
bar code length and the number of parameters selected, eXpress Config generates one or more bar codes for device
configuration. The bar codes contain configuration parameters for the wireless client in the mobile device and may also specify
the address of the Mobile Device Server.
Bar codes should be printed at a minimum of 600 dpi.
Step 2: Scan Bar Codes
For each mobile device to be configured, please follow these instructions.
Start eXpress Scan on the MX3Plus by double clicking the eXpress Scan icon.
Enter the bar code password, if any.
5-25