Filter
Top Products
Using LXEConnect
1. If an ActiveSync connection is has not been established, connect the MX3Plus to the PC.
2. Double-click the LXEConnect icon that was created on the desktop.
3. LXEConnect launches.
4. Click the OK button to dismiss the About CERDisp dialog box on the MX3Plus desktop by clicking the OK button in the
LXEConnect window on the PC desktop. The dialog box automatically times out and disappears after approximately 30
seconds.
5. The MX3Plus can now be configured from the LXEConnect window. Input from the PC’s mouse and keyboard are
recognized as if they were attached to the MX3Plus.
6. When the remote session is completed, terminate the LXEConnect program by selecting File > Exit or clicking on the X
in the upper right hand corner to close the application then disconnect the ActiveSync cable.
Note: After using LXEConnect, the MX3Plus cannot go into Suspend mode until after a warmboot. If using Power
Management on a MX3Plus, always warmboot the MX3Plus when finished using LXEConnect.
4-160