BMC Software, Inc., Confidential and Proprietary Information
4-6 Administrative Products for DB2 Installation Guide
Enabling the Product CLISTs
Figure 4-2 Setting the GENTABLE Variable in the BMCDB2 CLIST
SET BMCDB2T = &STR(BMC.DB2ADMN.D61.TLIB) /* CONTROL TABLE DATASET */
...
SET GENTABLE = Y /* USE GENERATED PERMANENT TABLE (Y/N) */
/* FOR CONTROL TABLE */
After you invoke the BMCDB2 CLIST, you must type GENERATE on
the command line. Refer to the BMCDB2T variable in the BMCDB2
CLIST for the location of the generated ISPF table.
• To add the CHANGE MANAGER product to the table shown in
Figure 4-1, which lists only the DASD MANAGER PLUS product, you
must add the line shown in Figure 4-3 (where vrm is the version, release,
and maintenance level) after the line for the ASU product:
Figure 4-3 Adding CHANGE MANAGER to the Control Table
*DATA
*PROD SSID D/I DOPT PLAN APPL COLL_ID NICKNAME
*----|----|-|--------|--------|----|------------------|-----------------
ACM DBAP D ACMDOPD1 CM
vrm
CDF ACMA *
• If CHANGE MANAGER was installed into a different set of libraries
than DASD MANAGER PLUS, you must also add the line shown in
Figure 4-4 (where HLQ is the high level qualifier(s) of the CHANGE
MANAGER libraries) to the bottom of the table:
Figure 4-4 Specifying the Location of CHANGE MANAGER Libraries
*DATA
*PROD SSID D/I DOPT PLAN APPL COLL_ID NICKNAME
*----|----|-|--------|--------|----|------------------|-----------------
ACM DBAP H HLQ *
