BMC Software, Inc., Confidential and Proprietary Information
3-10 Administrative Products for DB2 Installation Guide
Interacting with Other BMC Software Products
The variables in Table 3-3 and Table 3-4 are defined as follows:
• prd is the product code ARU for REORG PLUS or AMU for
LOADPLUS
• vr is the version and release installed for REORG PLUS and
LOADPLUS
• yy is the version and release number of your current DASD MANAGER
PLUS product. These table names are the default names as shipped and
may have changed when DASD MANAGER PLUS was installed.
Examine these synonyms and verify that the table names are correct. If your
current REORG PLUS, LOADPLUS, or COPY PLUS synonyms do not
point to the tables listed in Table 3-3 or Table 3-4, complete the following
steps to update them:
1. Drop the REORG PLUS, LOADPLUS, or COPY PLUS synonyms.
2. Create the new REORG PLUS, LOADPLUS, or COPY PLUS synonyms
by using the same synonym names, but with the correct DASD
MANAGER PLUS table names.
3. Bind the REORG PLUS, LOADPLUS, or COPY PLUS BMCSTATS
plan. BMC Software specifies this plan as ARUTvrmm, AMUTvrmm, or
ACPCvrmm, where vrmm is the version, release, and maintenance level.
Note: If DASD MANAGER PLUS tables are not connected or installed
when you install REORG PLUS, LOADPLUS, or COPY PLUS,
then the plan binds will complete with RC=4.
4. If you want to use DASD MANAGER PLUS with COPY PLUS, run the
ACPssidC ICOPY installation job.
The HLQ.INSTALL member DCI#ASUR for REORG PLUS, member
DCI#ASUL for LOADPLUS, and member DCI#ASUC for COPY PLUS
provide examples of a worklist for Step 1 and Step 2.
Pointing the DASD MANAGER PLUS Synonyms to the Utility Tables
DASD MANAGER PLUS uses the following synonyms:
• BMC_UTILITY for the BMCUTIL table
• BMC_UTIL_SYNC and BMC_UTIL_SYNC2 for the BMCSYNC table
