BMC Software, Inc., Confidential and Proprietary Information
3-2 Administrative Products for DB2 Installation Guide
Performing Additional Tasks for Installation
Performing Additional Tasks for Installation
Table 3-1 lists the tasks you may want to perform when you install BMC
Software products.
When you complete the installation, refer to Chapter 4, “Performing
Post-Installation Tasks” to perform post-installation tasks.
Installing Products at Different Times
The Install System allows you to install multiple products simultaneously.
However, you can install BMC Software products at different times. If you
install the products at different times and any of the products share the same
APF-authorized load library, you need to bind the products to the shared JCL
Generation and Execution Monitor components. To bind the products,
complete the steps in “Upgrading Shared Components” on page 3-4.
Table 3-1 Additional Tasks for Installation
Task Reference
Use the Install System to install BMC
Software products at different times.
See “Installing Products at Different
Times” on page 3-2.
Upgrade components that are shared
by the Administrative Products.
See “Upgrading Shared Components”
on page 3-4.
Use the Install System to allow the
Administrative Products to interact with
the BMC Software Utility and Backup
and Recovery products.
See “Interacting with Other BMC
Software Products” on page 3-6.
Reset the option values in the user
profiles.
See “Refreshing Default Options” on
page 3-13.
Use the Install System to install catalog
indirection.
See “Using Catalog Indirection” on
page 3-17.
Upgrade ALTER to CHANGE
MANAGER at the same or higher
maintenance level.
See “Migrating Data From ALTER to
CHANGE MANAGER” on page 3-28.
Maintain BMC Software Administrative
Products when you migrate between
versions of DB2.
See “Maintaining BMC Software
Administrative Products” on page 3-30.
