Overview
BMC Software, Inc., Confidential and Proprietary Information
Chapter 7 Installing CHANGE MANAGER 7-3
CHANGE MANAGER is able to use the BMC Software LOADPLUS,
UNLOAD PLUS, CHECK PLUS, REORG PLUS, RECOVER PLUS, and
COPY PLUS utilities to speed up the execution of structure changes and
migrations.
Refer to “Installation Considerations” on page 7-5 for specific considerations
and requirements for this product.
For information about CHANGE MANAGER, read the ALTER and
CHANGE MANAGER for DB2 User Guide.
CM/PILOT Component
The CM/PILOT (CM/P
®
) component of CHANGE MANAGER allows you
to automate DB2 change management tasks that are normally performed
through the CHANGE MANAGER Front End. With CM/P, you do not need
to decide which CHANGE MANAGER Front End panels are required for
your task and in what sequence you need to complete them—CM/PILOT
guides you with its ISPF dialog.
Predefined Scripts
The CM/PILOT dialog is based on predefined steps called Scripts. Each
Script contains ordered steps that prompt you for only the information that is
required to perform the change management task. You also have the
capability to modify various settings in each Script. CM/PILOT contains the
following scripts:
• change data structures using a Compare trigger
• change data structures using a DML trigger
• migrate data structures using a DML trigger
• change data structures using an existing Work ID
• migrate data structures using an existing Work ID
• receive data structure changes (strong sender)
• receive data structure changes (strong receiver)
• receive DDL to create data structures
• create a full-recovery baseline
• recover data structures with current data
• recover data structures with old data
