BMC Software, Inc., Confidential and Proprietary Information
4-42 Administrative Products for DB2 Installation Guide
Setting Up the Client
Note: Use of the LU name, MODE name, or TP name parameter allows
overrides to the client’s CPI-C Symbolic Destination Name table
entry. When all the parameters are used together, the CPI-C
Symbolic Destination Name table that is referenced is bypassed.
Where to Go from Here
After you configure the APPC SNA communication protocol, you verify the
setting for your host-code page. For more information, see “Confirming the
Host-Code Page for the MVS Server” on page 4-43.
Table 4-5 Installation Parameters
Parameter Description
Symbolic Destination Name
(required)
provides the CPI-C Symbolic Destination
Name that was defined in the SNA Gateway Server
to describe the MVS Server application
This parameter must match the exact name that is
used in the SNA Gateway Server setup.
LU Name
(optional)
describes the APPC LU name to be used
when establishing the conversation with the MVS
Server
This value should be specified as a fully qualified
SNA LU name. A qualified LU name consists of the
network name separated from the logical unit name
by a period, with each name not exceeding 8
characters.
MODE Name
(optional)
allows an overriding specification to the
operating mode-table entry for the connection to
the MVS Server
TP Name
(optional)
allows an overriding specification to the
teleprocessing program name that is associated
with the connection that identifies the MVS Server
