Default Option Descriptions
BMC Software, Inc., Confidential and Proprietary Information
Chapter 7 Installing CHANGE MANAGER 7-31
TABLEALL=N For DB2 Version 5.1 and later, specifies the STATS utility to gather
information for all columns of tables.
N Do not include the TABLE(ALL) parameter on stand-alone stats
runs.
Y Include the TABLE(ALL) parameter on stand-alone stats runs.
TAPE1=CART, TAPE2=TAPE, TAPE3=TAPE
Defines the valid installation tape unit names for your site.
TIMEPARM Indicates the TIME limit in minutes for each step in a batch job stream.
TSOSX=N Specifies whether your site uses the TSO Submit exit to supply the job
statements at submit time (
Y or N).
UNLDCOLL=N Explicit column list that is required on all BMC Software UNLOAD PLUS
unloads (
Y or N).
UNLDEMPT=Y For DB2 Version 5.1 and later, specifies whether tables that RUNSTATS
indicates are empty are unloaded.
UPDSTATS=C For DB2 Version 5.1 and later, specifies which statistics are updated. The
DOPTs parameters are defined as follows:
A All—The DASD tables and the DB2 Catalog tables are updated.
BMCSTATS is selected.
B BMC DASD tables—Only the DASD tables are updated.
BMCSTATS is selected.
C DB2 Catalog—Only the DB2 Catalog tables are updated.
RUNSTATS is selected.
UTILCOPY=N Determines whether other utilities or a copy utility creates an image copy
during loads.
Y Image copies are created by utilities other than the copy utilities
whenever possible. If the utilities cannot create a copy, a separate
copy step is generated.
N A separate copy step generates all copies that the specific copy utility
takes (either the IBM COPY utility or the BMC Software COPY
PLUS utility).
VVALPROP=N Specifies whether text propagation for extended views is supported by
ALTER or CHANGE MANAGER (
Y or N).
VRM=vrmmd Indicates the version, release level, maintenance level, and DB2 exploited
version (where B indicates version 3.1, C indicates version 4.1, D indicates
version 5.1, and E indicates version 6.1 or later).
