BMC Software, Inc., Confidential and Proprietary Information
2-12 Administrative Products for DB2 Installation Guide
Starting the Install System
Figure 2-3 Install System—Load Library Specification
Step 2 In the LOADLIB Name field, type the name of the Install System load library
(File 2 of the distribution tape).
If you unloaded File 2 as instructed on page 2-6, this is the name of the load
library as specified in the job that you used to unload the Install System from
the distribution tape.
Step 3 If you followed the unload procedure on page 2-6 (or if you have already
completed Steps 3.A through 3.E) specify
N in the next field, and press Enter.
If you did not unload File 2 as instructed on page 2-6, complete the following
steps:
3.A Type Y in the selection field, and press Enter.
3.B Type the appropriate job card, tape, and load library information in
the Unload LOADLIB panel, and press
Enter to generate the JCL.
3.C Review the JCL member ($$UNLOAD) and edit it as necessary.
3.D Run the job that unloads the load library from the tape.
3.E Return to Step 1 of this procedure and start the Install System again.
Install System Load Library Specification
Command ===> __________________________________________________________________
Enter the Install System LOAD Library name ( File 2 on the Product Tape ).
Note that this is not a product LOAD library.
It is a LOAD library used to run the installation dialog.
If the LOADLIB is valid, press Enter to continue.
LOADLIB Name . . . . 'BMC.DCI.INSTALL.LOAD'
Note: If you have not unloaded the Install LOADLIB, enter Y below.
After the unload completes successfully, restart the Install.
To generate a batch job to unload File 2, type Y . . . N
F1=HELP F2=SPLIT F3=END F4=RETURN F5=RFIND F6=RCHANGE
F7=UP F8=DOWN F9=SWAP F10=LEFT F11=RIGHT F12=RETRIEVE
