Starting the Install System
BMC Software, Inc., Confidential and Proprietary Information
Chapter 2 Using the Install System 2-11
When the BMC Software products run, the owner of the synonyms is
obtained from the QUALIFIER value of the processing plan. When the
owner is known, the object to which the synonym applies is also known.
When you specify a synonym qualifier
• Select NEW status if the qualifier is currently not in use by any other
BMC Software product in the target DB2 subsystem.
• Select USED/REUSE status if the BMC Software product is
currently using the qualifier, but this usage can be replaced.
For example, if you previously installed a BMC Software product with a
qualifier of ALU33D and want to install a new release of the same
product using the same qualifier ALU33D, select USED/REUSE.
Synonyms referencing the old environment are dropped so that synonyms
referencing the new environment can be created.
Warning! Reusing existing qualifiers invalidates processing of the
product release that is already installed.
To Start the Install System
Step 1 In the TSO Commands Utility panel, type the following command:
EX 'HLQ.INSTALL(DCIINSTL)' 'HLQ'
For example, the following command uses the high-level qualifier BMC.DCI:
EX 'BMC.DCI.INSTALL(DCIINSTL)' 'BMC.DCI'
The Install System displays the Load Library Specification panel (see
Figure 2-3 on page 2-12).
