BMC Software, Inc., Confidential and Proprietary Information
4-20 Administrative Products for DB2 Installation Guide
Verifying the Installation of the Administrative Products
Verifying the Installation of the Administrative Products
Summary: This section describes the steps that you must complete to verify that the
Administrative Products that have an ISPF interface have been installed
correctly.
Step 1 Invoke the BMCDB2 CLIST. Verify that all the products appear on the
BMCDB2PR panel that is displayed.
Step 2 Type CONTAB on the command line. On the BMCDB2TB panel, verify that
the correct partitioned data set (PDS) and member name are displayed in the
library in which the BMCDB2 CLIST is located. If they are not, set the
BMCDB2C variable in the BMCDB2 CLIST to the correct library. Exit the
CONTAB panel.
Step 3 Type TSO BMCMSG BMCnnnnn on the command line, where nnnnn is a
valid message number (for example, BMC45680). Verify that a message is
displayed. Press
F3 to exit the BMCMSG CLIST.
Step 4 Select one of the products that you installed.
Step 5 At the main menu for the Administrative Products, type ENVI on the
command line.
Note: For DASD MANAGER PLUS, select the environment option.
Step 6 Review the environment panel to verify the displayed information. Exit the
ENVI panel.
Step 7 Repeat Step 4 through Step 6 for each product that you installed.
Note: If you are installing CATALOG MANAGER and are using the
Distributed Data Facility (DDF), enter
CONNECT on the command
line (from CATALOG MANAGER). The CATALOG MANAGER
Connect panel appears. Then, verify connections or attachments to
other DB2 subsystems.
