Configuring TCP/IP
BMC Software, Inc., Confidential and Proprietary Information
Chapter 4 Performing Post-Installation Tasks 4-23
Configuring TCP/IP
Summary: This section describes the steps that you must perform if you select TCP/IP
as your communication protocol for the MVS Server.
Step 1 Edit the INI#ACV file.
The PATROLDB member is the started task that enables the clients to
communicate with DB2. PATROLDB uses the initialization file INI#ACV to
establish the TCP/IP address (port address), as well as the default options
(DOPTs) that the MVS Server uses.
After you complete the installation, the members INI#ACV and PATROLDB
are placed in the HLQ.CNTL data set. The INI#ACV member contains the
TCP/IP port number that the MVS Server monitors. If an incorrect port
number is specified during installation, you can edit it manually in INI#ACV.
You do not need to register your port in the TCP/IP profile data set.
Figure 4-14 on page 4-24 shows an example of an INI#ACV member.
