Filter
Top Products
Operating and maintenance instructions Section 7: Parts list
3-9008-701 Rev J January 2015
General 89
Section 7: Parts list
7.1 General
This section contains those parts required to properly maintain and service a standard compact
prover. Reference those drawings applicable to the specific prover size and configuration. See
Figure 7-1, Figure 7-2 and Figure 7-3.
7.2 Replacement Parts List
Table 7-1 is a list of the parts that may require replacement in the Compact Prover. Parts listed as
‘N/S’, are not shown in the figures. A part number designated as ‘N/A’ is not applicable. A part
number designated as ‘C/F’ will require factory consultation.
If a part is necessary for repair of the Compact Prover and is not listed in Table 7-1, contact a
Daniel representative or the factory for assistance. The following information will be needed to
properly identify the part(s) needed for repair:
• Compact prover serial number
• Compact prover model number
• Compact prover size (i.e. 8”, 12”Mini, 12”, 18”, 24”, 34” or 40”)
• Part description and number (if available)
• Quantity required
The following companies are quality manufacturers of the components parts used in
construction of the compact prover:
Daniel® Compact Prover™ Daniel Measurement and Control, Emerson Process
Management
Kalrez ® E.I. du Pont de Nemours and Company
Rosemount Rosemount, Inc.
Teflon® E.I. du Pont de Nemours and Company
Viton® E.I. du Pont de Nemours and Company
Neoprene™ E.I. du Pont de Nemours and Company
Viton® is a registered trademark of E.I. du Pont de Nemours and Company.