Filter
Top Products
Operating and maintenance instructions Section 2: Installation and set-up
3-9008-701 Rev J January 2015
Calibration integrity seal installation procedure 25
Step 1 Once the seal nut is securely tightened in place (see Figure 2A); insert the braided wire
through the hole in the nut as shown in Figure 2B.
Step 2 Wrap the braided wire around the support plate (see Figure 1B).
Step 3 Insert the two ends of the braided wire through the lead seal and slide the seal up the
wire until the slack has been pulled out of the wire (see Figure 3A).
Step 4 Secure the seal using a clamping set of pliers thus closing the holes in the lead seal around
the braided wire.
The final result should appear similar to Figure 1B.