Filter
Top Products
FI0154601-00 C A-1
A Command Reference
The command line interface (CLI) enables you to perform a variety of router
management tasks through an Ethernet or serial port connection. This section
describes the following:
Logging on to a SAN Router
Guest Account (see page A-2)
Working with SAN Router Configurations (see page A-2)
Commands (see page A-5)
Logging on to a SAN Router
To log on to a router using Telnet, open a command line window on the
workstation and enter the telnet command followed by the router IP address:
# telnet <ip_address>
A Telnet window opens prompting you to log in. Enter an account name and
password.
To log on to a switch through the serial port, configure the workstation port with the
following settings:
115200 baud
8-bit character
1 stop bit
No parity
Enter an account name and password when prompted.