Filter
Top Products
B – Configuring CHAP
Configuring CHAP Using the GUI
FI0154601-00 C B-5
A
7. Type the IQN name string.
8. Select Enable CHAP.
9. Create a CHAP secret (for example, secret_initiator).
10. Go to the MS Initiator and perform the following steps:
a. Click General.
b. Click Secret (in the middle of the screen).
c. If this is the first time you are setting secrets, reset all secrets.
d. Type the CHAP secret (secret_port) that you created in Step 5.
11. Click Discovery.
12. Click Add.
13. Enter the address of the iSCSI port of the bridge.
14. Click Advanced.
15. Select Chap Login Information.
16. Type the secret (secret_initiator) that you created in Step 9 into Target
Secret.
17. Select Mutual Authentication.
18. Click OK.
19. Click OK. The initiator completes discovery.
GUI—Discovery Session—Uni-directional CHAP
To program a single-direction CHAP during a discovery session:
1. Do not enable CHAP on the iSCSI port.
2. Check to see if the initiator exists on the discovered iSCSI initiators list:
If the initiator is not part of the discovered iSCSI initiators list, then
open the Wizard menu and select Add Initiator Wizard.
If the initiator is part of the discovered list, then go to Step 6.
3. Type the IQN name string.
4. Select Enable Chap.
5. Create a CHAP secret (for example, secret_initiator).
6. Go to the MS Initiator and perform the following steps:
a. Click Discovery.
b. Click Add.