Filter
Top Products
2 – General Description
Fibre Channel Ports
FI0154601-00 C 2-5
A
Erases all presentations.
Erases all discovered initiators and targets.
Fibre Channel Ports
The SANbox 6140 router has two Fibre Channel 1-Gbps/2-Gbps ports. The ports
are labeled FC1 and FC2, as shown in Figure 2-4.
Figure 2-4 Fibre Channel LEDs
Each port is served by a small form-factor pluggable (SFP) optical transceiver and
is capable of 1-Gbps or 2-Gbps transmission. SFPs are hot-pluggable. User ports
can self-discover both the port type and transmission speed when connected to
public devices or switches. The port LEDs are located to the right of their
respective ports and provide status and activity information.
Fibre Channel Port LEDs
Each port has three LEDs:
The amber LED (top) shows activity (data is passing through the port).
The green LED (middle) shows the logged-in or initialization status of the
connected devices. This LED flashes off to show the link rate, once for
1-Gbps speed, and twice for 2-Gbps speed.
The yellow (bottom) LED shows an alert (port fault) condition.
Table 2-2 describes the LED blink patterns and their meanings.
Table 2-2. Port LEDs
Activity Amber LED Green LED Yellow LED
Power OFF
OFF OFF OFF
Power ON
(before firmware
initialization)
ON ON ON