Filter
Top Products
C – Log Messages
Error Log Messages
C-8 FI0154601-00 C
S
1035 Login attempted using Fibre Channel VP index that has not been configured.
Operation attempted on an unconfigured VP.
1042 Attempting login but Fibre Channel connection cannot be opened.
1064 Attempting logout of device for which there is no active path (WWPN not
found).
1067 Logout attempted using Fibre Channel VP index that has not been config-
ured. Operation attempted on an unconfigured VP.
1108 Event notification; Fibre Channel processor encountered a system error
(unrecoverable firmware error).
1109 Event notification; Fibre Channel driver encountered a fatal error.
1112 Event notification; Fibre Channel port logged out.
1282 Failed to allocate object for iSCSI session; out of session resources.
1292 Received iSCSI PDU with duplicate command sequence number (CmdSN).
Command PDU will be dropped.
1298 Unable to allocate iSCSI initiator object while instantiating session.
1444 Failed to execute iSCSI Command PDU because its CmdSN is out-of-range.
Log message contains the incorrect CmdSN, the valid CmdSN range, the
first byte of the CDB, and the data length.
274 iSCSI login failed between receipt of PDU and request for the data segment.
278 iSCSI login failed due to unsupported version number in received login PDU.
297 iSCSI Login PDU contains invalid initiator name. The format and character
set used to form the initiator name is invalid.
305 iSCSI target login was attempted to a portal (iSCSI1 or iSCSI2) on which the
target is not presented.
307 iSCSI Login PDU received for a target with a target name unknown to the
router.
308 iSCSI Login PDU received without a target name for a normal session.
310 iSCSI Login PDU received without an initiator name key/value.
312 iSCSI Login PDU received with an incorrect initiator task tag for a session
which is partially logged in. This would occur if a login PDU other than the
initial login PDU used an initiator task tag which was different than the initia-
tor task tag provided in the initial login PDU.
323 iSCSI Login PDU was received with a TSIH out of range. This would occur if
the iSCSI initiator attempting the login failed to used the TSIH value provided
in the Target Login Response PDU (router is target) in subsequent login
PDUs.