Filter
Top Products
7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
FI0154601-00 C 7-15
A
If you selected the Use the following IP address radio button,
you can configure the IP address.
Subnet Mask – Displays the management port’s subnet mask.
If you selected the Obtain an IP address automatically
(DHCP), the system obtains the subnet mask automatically
through DHCP.
If you selected the Use the following IP address radio button,
you can configure the subnet mask.
Gateway – Displays the IP address of the server acting as a gateway
to your Internet connection.
If you selected the Obtain an IP address automatically
(DHCP), the system obtains the gateway address automatically
through DHCP.
If you selected the Use the following IP address radio button,
you can specify the gateway address.
IPv6 Management Info – Select this check box to use IPv6 (Internet
Protocol version 6, 128-bit addressing), then use the radio buttons to identify
whether to use either a dynamic or static IP address.
IPv6 Address1 – The first user-assigned IPv6 address to which the
port responds. A value of :: indicates that an IPv6 address has not
been assigned. Although you may modify the IP address in this
window, you will typically set it using the Configuration Wizard.
IPv6 Address2 – The second user-assigned IPv6 address to which
the port responds. A value of :: indicates that an IPv6 address has not
been assigned. Although you may modify the IP address in this
window, you will typically set it using the Configuration Wizard.
IPv6 Default Router – Use this address to set the default router for the
IPv6. The system can also set the IPv6 default router dynamically
depending on your network configuration.
IPv6 Local Link – This field contains the IPv6 link local address of the
port. It is not editable.
Set IP Address – After making any IP address changes, click this button to
save your changes.
NOTE:
IPv6 support is available only with hardware version 6 and greater and
software version 2.4.0.0 and greater.