Filter
Top Products
A – Command Reference
Commands
FI0154601-00 C A-37
A
Set System Command
Configures the general router parameters.
Authority Admin session
Syntax set system
Examples The following example shows the set system command:
QRouter (admin) #> set system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING:
If enabled by operator, the Symbolic Name can be embedded as part of
the Only valid iSCSI name characters will be accepted. Valid
characters include alphabetical (a-z, A-Z), numerical (0-9), colon,
hyphen, and period.
Changes to the Settings below will be effective after a reboot.
System Symbolic Name (Max = 64 characters) [alpha1 ]
Embed Symbolic Name (0=Enable,1=Disable) [Disabled ]
Target Presentation Mode (0=Auto, 1=Manual) [Auto ]
Lun Mapping (0=Enable, 1=Disable) [Enabled ]
System Log Level (Min = 0, Max = 3) [0 ]
All attribute values that have been changed will now be saved.