Filter
Top Products
2 – General Description
Chassis Controls
2-4 FI0154601-00 C
S
Reset and Select Boot Image
You can reset the router using either the primary or secondary boot image:
Primary Image – To reset the router and select the primary boot image, use
a pointed, nonmetallic tool to press and hold the maintenance button until
the heartbeat LED flashes once, then release the button. The router will boot
from the primary boot image. The boot time is less than one minute.
Secondary Image – To reset the router and select the secondary boot
image, use a pointed, nonmetallic tool to press and hold the maintenance
button until the heartbeat LED flashes twice, then release the button. The
heartbeat LED flashes twice. The router boots from secondary boot image.
The boot time is less than one minute.
Reset IP Address
To reset the router and restore the maintenance port IP address to the default
(10.0.0.1), use a pointed, nonmetallic tool to press and hold the maintenance
button until the heartbeat LED flashes six times, then release the button. The
router boots and sets the maintenance port to IP address 10.0.0.1. The boot
time is less than one minute.
The IP address set by this method is not persistent; to make the change
persistent, use the command line interface (CLI) or SANsurfer Router Manager to
set the IP address. For more information, see page 7-14 and page A-30.
Enable DHCP
To reset the router and configure the maintenance port to use DHCP to acquire its
IP address, use a pointed, nonmetallic tool to press and hold the maintenance
button until the heartbeat LED flashes seven times, then release the button. The
router boots and configures the maintenance port for DHCP. The boot time is less
than one minute.
Enabling DHCP by this method is not persistent; to make the change persistent,
use the command line interface (CLI) or SANsurfer Router Manager to enable
DHCP. For details, see page 7-14 and page A-33.
Restore Factory Defaults
To reset the router and restore it to the factory default configuration, use a pointed,
nonmetallic tool to press the maintenance button and hold it until the heartbeat
LED flashes 20 times, then release the button. The router boots and is restored to
the factory defaults. The boot time is less than one minute.
The router does the following when restored to the factory defaults:
Resets all passwords.
Resets the maintenance port IP address to 10.0.0.1.
Disables the iSCSI ports and sets the IP address to 0.0.0.0.