Filter
Top Products
7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
FI0154601-00 C 7-17
A
NTP Server 3 – Displays the IP address of the third NTP server to be
queried by the router when setting its time and date. This server is used only
if the first and second NTP servers did not respond. If your hardware
supports IPv6, you may choose the appropriate IP protocol of the NTP
server, either IPv4 or IPv6, then enter the IP address using the appropriate
notation.
NTP Server 4 – Displays the IP address of the fourth NTP server to be
queried by the router when setting its time and date. This server is used only
if the first, second, and third NTP servers did not respond. If your hardware
supports IPv6, you may choose the appropriate IP protocol of the NTP
server, either IPv4 or IPv6, then enter the IP address using the appropriate
notation.
Set NTP Address – After enabling NTP Servers and setting their IP
addresses, click this button to save any changes made to the NTP server IP
addresses.
Security Information
Select the fourth vertical tab on the router’s Information tabbed page to display
the Security tabbed page.
Figure 7-16 Information Tabbed Page - Security Information
The Security Information tabbed page enables you to set the router’s password.
The Security tabbed page provides the following parameters:
Current Password – You must enter the current password before changing
it.
New Password – Enter the new router password.
Verify New Password – Verify the password entered in the New Password
field.
Apply – Click this button to save the password changes.
Clear Fields – Click this button to clear the Current Password, New
Password, and Verify Password fields.