Filter
Top Products
2 – General Description
Chassis Controls
FI0154601-00 C 2-3
A
Chassis Controls
The maintenance button shown in Figure 2-3 is the only chassis control. Press
this button to reset the router or to recover the router if it becomes disabled.
Figure 2-3 Chassis Controls
Maintenance Button
The maintenance button is a multifunction momentary switch on the front panel. It
has the following functions:
Reset a Router (see page 2-3)
Reset and Select Boot Image (see page 2-4)
Reset IP Address (see section page 2-4)
Enable DHCP (see section page 2-4)
Restore Factory Defaults (see page 2-4)
Reset a Router
To reset the router, use a pointed, nonmetallic tool to momentarily press and
release (less than two seconds) the maintenance button. The router responds as
follows:
1. All the chassis LEDs illuminate.
2. After about 2 seconds, the POST begins, turning off the heartbeat and
system fault LEDs.
3. When the POST is complete, the power LED is on and the heartbeat LED
flashes once per second.