Filter
Top Products
A – Command Reference
Commands
FI0154601-00 C A-35
A
Set SNMP Command
Configures the general simple network management protocol (SNMP) properties,
as well as configuring eight trap destinations.
Authority Admin session
Syntax set snmp
trap_destinations
Keywords trap_destinations
Specifies the setting of the trap destinations.
Examples The following example shows the set snmp command for setting the general
properties:
QRouter (admin) #> set snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP :
-----------------
Read Community [ ] Public
Trap Community [ ] Private
System Location [ ]
System Contact [ ]
Authentication Traps (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be saved.
The following example shows configuring an SNMP trap destination:
QRouter (admin) #> set snmp trap_destinations
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP Trap Destination 1 :
-------------------------------------