Filter
Top Products
A – Command Reference
Commands
A-6 FI0154601-00 C
S
Admin Command
Opens and closes an administrator session. Any command that changes the
router configuration requires that the user be in an Admin session. Only one
Admin session can be open on the router at any time. An inactive Admin session
will time out after a period of 15 minutes.
Authority Admin session
Syntax admin
start (or begin)
end (or stop)
cancel
Keywords start (or begin)
Opens the Admin session.
end (or stop)
Closes the Admin session. The logout, shutdown, and reset commands also
end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this keyword with
care, because it terminates the Admin session without warning the other user and
without saving pending changes.
Notes Closing a Telnet window during an Admin session does not release the session. In
this case, you must either wait for the Admin session to time out, or use the Admin
cancel command.
Examples The following example shows how to open and close an Admin session:
QRouter #> admin start
Password : ******
QRouter(admin) #>
.
.
.
QRouter(admin) #> admin end
QRouter #>