Filter
Top Products
B – Configuring CHAP
Configuring CHAP Using CLI
FI0154601-00 C B-3
A
6. Type the address of the iSCSI port of the router.
7. Click Advanced.
8. Select Chap Login Information.
9. In Target Secret, type the secret (secret_initiator) you created in Step 2.
10. Click OK.
11. Click OK. The initiator should complete discovery.
CLI—Normal Session—Bi-directional CHAP
To configure a bi-directional CHAP used during a normal session:
1. On the router
a. Enable CHAP on the presented target to which the initiator will login.
b. Create a secret (for example, secret_target).
c. Use Set CHAP.
2. Use the initiator add command to add the initiator that is about to do a
normal login:
a. Enable the CHAP for this initiator.
b. Create a secret (for example, secret_initiator).
c. Use the set chap command to update the CHAP settings of the
initiator.
3. Go to the MS Initiator and perform the following steps:
a. Click General.
b. Click Secret (in the middle of the screen).
c. If this is the first time you are setting secrets, reset all the secrets.
d. Type the secret (secret_target) that you created in Step 1.
4. Click Targets.
5. Select the target you want to login to.
6. Click Advanced.
7. Select Chap Login Information.
8. Type the secret (secret_initiator) that you created in Step 2 into Target
Secret.
9. Select Mutual Authentication.
10. Click OK.
11. Click OK. The initiator completes the normal login.