Filter
Top Products
4 – Installation
Installing the SANbox 6140 Router
4-10 FI0154601-00 C
S
To configure the router using the command line interface:
1. Open a command window according to the type of workstation and
connection:
Ethernet (all platforms): Open a telnet session with the default router
IP address and log in to the router with the default account name and
password (guest/password):
telnet 10.0.0.1
username: guest
password: ********
Serial – Windows: Open the HyperTerminal application on a Windows
platform:
a. From the Windows Start menu, select Programs >
Accessories, HyperTerminal > HyperTerminal.
b. Select the connection you created earlier and click OK.
Serial – Linux: Open a command window and enter the following
command:
minicom
2. Open an admin session and enter the commands to setup both iSCSI ports
and the management interface. See Appendix A for command descriptions.
QRouter #> admin start
Password : ******
QRouter (admin) #> set mgmt
………………………
QRouter (admin) #> set iscsi 1
………………………
QRouter (admin) #> set iscsi 2
………………………
Cable Devices to the Router
Connect cables to the SFP transceivers and their corresponding devices.
Devices can have SFP (or SFF) transceivers or gigabit interface converters
(GBIC). LC-type duplex fiber optic cable connectors are designed for SFP
transceivers, while SC-type connectors are designed for GBICs. Choose the
fiber optic cable with the connector combination that matches the device
being connected to the router.