Filter
Top Products
7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
FI0154601-00 C 7-19
A
SNMP Settings
Read Community – Enter a password that authorizes an SNMP
management server to read information from the router. This is a write-only
field. The value on the router and the SNMP management server must be
the same. The read community password can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is public.
Trap Community – Enter a password that authorizes an SNMP
management server to receive traps. This is a write-only field. The value on
the router and the SNMP management server must be the same. The trap
community password can be up to 32 characters excluding the number sign
(#), semicolon (;), and comma (,). The default is private.
System Location – Specifies the name of the router location. The name can
be up to 64 characters excluding the number sign (#), semicolon (;), and
comma (,).
System Contact – Specifies the name of the person to be contacted to
respond to trap events. The name can be up to 64 characters excluding the
number sign (#), semicolon (;), and comma (,).
Authentication Traps – Enables or disables the generation of
authentication traps in response to authentication failures.
SNMP Trap Receivers
Enabled SNMP Trap Receivers – Select this check box to enable the trap
receiver fields you can use to specify each IP address, trap port, and trap
version. The router can support up to eight trap addresses. For each entry,
set the following fields:
IP Protocol – Select the IP protocol version from the drop-down list
box: IPv6 Address or IPv4 Address. The corresponding IP Address
field changes to accept the appropriate format.
IP Address – Specifies the IP address to which the SNMP traps are
sent.
Trap Port – Identifies the port number on which the trap is sent. The
default is 162.
Trap Version – Specifies the SNMP version (1 or 2) with which to
format traps.