Filter
Top Products
B – Configuring CHAP
Configuring CHAP Using the GUI
B-6 FI0154601-00 C
S
c. Enter the address of the iSCSI port of the bridge.
d. Click Advanced.
e. Click Chap Login Information.
f. Type the secret (secret_initiator) you created in Step 5 into Target
Secret.
7. Click OK.
8. Click OK. The initiator completes discovery.
GUI—Normal Session—Bi-directional CHAP
To program bi-directional CHAP during a normal session:
1. On the bridge, enable CHAP for the iSCSI presented target.
2. Select the presented target on the left column of the SANsurfer Router
Manager.
3. Click Information.
4. Select Enable Chap.
5. Type a secret in the Chap secret dialog box (for example, secret_target).
6. Check to see if the initiator exists on the discovered iSCSI initiators list:
If the initiator is not part of the discovered iSCSI initiators list, then
open the Wizard menu and select Add Initiator Wizard.
If the initiator is part of the discovered list, then go to Step 10.
7. Fill in the IQN name string.
8. Select Enable Chap.
9. Create a CHAP secret (for example, secret_initiator).
10. Go to the MS Initiator and perform the following steps:
a. Click General.
b. Click Secret (in the middle of the screen).
c. If this is the first time you are setting secrets, reset all the secrets.
d. Type the secret (secret_target) that you created in Step 5.
11. Click Targets.
12. Select the target you want to login to.
13. Click Log On.
14. Click Advanced.