Filter
Top Products
Setting Description
For example, if the starting IP address is
192.168.0.250 and the subnet mask is
255.255.0.0 then the QuickDeploy IP address
for slot 15 is
192.168.0.265. If the subnet mask
is 255.255.255.0, the QuickDeploy IP
address range is not fully within
QuickDeploy Subnet
error message is
displayed when you click Save QuickDeploy
Settings or Auto-Populate Using QuickDeploy
Settings.
iDRAC IPv4 Netmask Specifies the QuickDeploy subnet mask that is
assigned to all newly inserted servers.
iDRAC IPv4 Gateway Specifies the QuickDeploy default gateway that
is assigned to all the DRAC present in the
chassis.
Enable iDRAC IPv6 Enables IPv6 addressing for each iDRAC present
in the chassis that is IPv6 capable.
Enable iDRAC IPv6 Autoconfiguration Enables the iDRAC to obtain IPv6 settings
(address and prefix length) from a DHCPv6
server and also enables stateless address auto
configuration. By default, this option is enabled.
iDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned
to the iDRACs. The default value is "::".
iDRAC IPv6 Prefix Length Specifies the prefix length to be assigned for the
IPv6 addresses on the iDRAC. The default value
is 64.
3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC
network setting, click Apply iDRAC Network Settings to deploy the settings to the iDRAC.
The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If
Set iDRAC Root Password on Server Insertion and QuickDeploy Enabled are enabled, the user is
prompted using the LCD interface to allow or not allow the password change. If there are network
configuration settings that differ from the current iDRAC settings, the user is prompted to either
accept or reject the changes.
NOTE: If there is a LAN or IPMI over LAN difference, the user is prompted to accept the
QuickDeploy IP address setting. If the difference is the DHCP setting, the user is prompted to
accept the DHCP QuickDeploy setting.
To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate
Using QuickDeploy Settings. The QuickDeploy network configurations settings are copied into the
corresponding fields in the iDRAC Network Configuration Settings table.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more
iDRAC server network configuration settings may require a couple of minutes to propagate
from CMC to iDRAC. Clicking Refresh early may display only partially correct data for one or
more iDRAC servers.
101