Filter
Top Products
Mapping a Server to KVM Using CMC Web Interface
Make sure the KVM console is connected to the chassis.
To map a server to a KVM:
1. In the left pane, click Chassis Overview → Front Panel → Setup .
2. On the Front Panel Configuration page, under the KVM Configuration section, from the KVM
Mapped
list, select the slot that must be mapped to a KVM, and then click Apply.
NOTE: The KVM allows mapping to all the server slots. Inserting a full–height or replacing a half–
height server with full–height server does not change the mapping behavior. However, if the KVM is
mapped to a lower slot and the slot has a full–height server, then the KVM is available only through
the upper slot. You must remap the KVM to the upper slots.
Mapping the Server to KVM Using LCD
Make sure the KVM console is connected to the chassis.
To map the server to the KVM using the LCD — From the Main Menu screen on the LCD, go to KVM
Mapping, select the server that must be mapped, and then press OK.
Mapping a Server to a DVD Drive
To map the server to the chassis DVD drive:
1. In the left pane, click Chassis Overview → Front Panel → Setup .
2. On the Front Panel Configuration page, under the DVD Drive Configuration section:
From the DVD Mapped drop-down menu, select one of the servers. Select the servers for which
chassis DVD drive access is required.
3. Click Apply.
The DVD allows mapping to all the server slots. Inserting a full–height or replacing a half–height server
with full–height server does not change the mapping behavior. However, if the DVD is mapped to a lower
slot and the slot has a full–height server, then the DVD is available only through the upper slot. You must
remap the DVD to the upper slots.
44