Filter
Top Products
Assigning QuickDeploy IP Address to Servers
The figure here shows the QuickDeploy IP addresses assignment to the servers when there are four half-
height servers in VRTX chassis:
The following figure shows the QuickDeploy IP addresses assignment to the servers when there are two
full-height blades in VRTX chassis:
Modifying iDRAC Network Settings for Individual Server iDRAC
Using this feature, you can configure the iDRAC network configurations settings for each installed server.
The initial values displayed for each of the fields are the current values read from the iDRAC. To use this
feature, you must have an Enterprise License.
To modify the iDRAC Network Settings:
1. In the left pane, click Server Overview, and then click Setup. On the Deploy iDRAC page the iDRAC
Network Settings
section lists the iDRAC IPv4 and IPv6 network configuration settings of all the
installed servers.
2. Modify the iDRAC network settings as required for the server(s).
NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For
information about the fields, see the Online Help.
3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. Any changes made to the
QuickDeploy Settings are also saved.
The iDRAC Network Settings table reflects future network configuration settings; the values shown
for installed servers may or may not be the same as the currently installed iDRAC network
configuration settings. Click Refresh to update the iDRAC Deploy page with each installed iDRAC
network configuration settings after changes are made.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more
iDRAC server network configuration settings may require a couple of minutes to propagate
from CMC to iDRAC. Clicking Refresh too soon may display only partially correct data for a one
or more iDRAC servers.
Modifying iDRAC Network Settings Using RACADM
RACADM config or getconfig commands support the -m <module> option for the following
configuration groups:
• cfgLanNetworking
• cfgIPv6LanNetworking
• cfgRacTuning
102