Filter
Top Products
64 IBM 9077 SP Switch Router: Get Connected to the SP Switch
Next, ensure that the following parameters are defined:
ParametersDescriptions
GRF IP addressThe IP address for the GRF administrative Ethernet.
GRF netmaskThe Netmask for the GRF administrative Ethernet.
GRF Default routeThe default route of the GRF.
SNMP community nameThis attribute describes the SNMP community
name that the SP Extension Node SNMP Manager
and the GRF’s SNMP Agent will send in the
corresponding field of the SNMP messages. This
value must match the value specified for the same
attribute of the corresponding dependent node
definition on the SP system. If left blank, a default
name found in the SP Switch Router Adapter
documentation is used.
CWS IP addressThe Control Workstation’s IP address. When a GRF
contains multiple SP Switch router adapters that
are managed by different SNMP managers on
different RS/6000 SP CWS, each of the Control
Workstation IP addresses should be defined along
with a different community name for each Control
Workstation.
DNSThe DNS server and domain name, if used.
SP Extension Node SNMP
Manager port #The SNMP port number used by the SP Extension Node
SNMP Manager to communicate with the SNMP
agent on the GRF.
This port number is 162 when the SP Extension
Node SNMP Manager is the only SNMP manager
on the Control Workstation. Otherwise, another
port number not used in the /etc/services of the
Control Workstation is chosen.