Filter
Top Products
Installation and Configuration 72
system and enter these basic configuration parameters. Procedures for
starting and setting up the SP Switch Router are found in
GRF 400/1600
Getting Started V.14,
GA22-7368.
Ignore the prompts for network logging, since we will configure logging to
a PCMCIA device; just press Enter
when asked to enter the remote
logging host name or its IP address.
• Remote Telnet access is working. To enable it, you have to edit the /etc/
ttys file on the SP Switch Router and modify the appropriate entries, as
follows:
Adding
secure to a ttypX stanza opens it for Telnet, so in this example, only
two Telnet sessions at a time were allowed.
Use the following command to connect to the SP Switch Router:
xterm -sb -geometry 80x65 -e telnet <hostname of SP Switch Router>
This gives you a large window with a scroll bar at the left, so that you may
retrieve information easier. See Appendix B.1, “/root/.profile” on page 261
for a modified .profile for the root user.
Hint:
If you just use -e telnet and give the hostname at the telnet>
prompt, the window will survive reboots of the GRF.
#name getty type status comments
ttyp0 none network secure
ttyp1 none network secure
ttyp2 none network
ttyp3 none network