Filter
Top Products
E6581301
F-52
6
6.30 Acceleration/deceleration 2
6.30.1 Setting acceleration/deceleration patterns and switching
acceleration/deceleration patterns 1, 2, 3 and 4
H
HH
H
: Acceleration time 2
H
HH
H
: Deceleration time 2
H
HH
H
: Acceleration/deceleration 1 pattern
H
HH
H
: Acceleration/deceleration 2 pattern
H
HH
H
: Panel acceleration/deceleration selection
H
HH
H
: Acceleration/deceleration switching frequency 1
H
HH
H
: Acceleration S-pattern lower limit adjustment
H
HH
H
: Acceleration S-pattern upper limit adjustment
H
HH
H
: Deceleration S-pattern lower limit adjustment
H
HH
H
: Deceleration S-pattern upper limit adjustment
H
HH
H
: Acceleration time 3
H
HH
H
: Deceleration time 3
H
HH
H
: Acceleration/deceleration 3 pattern
H
HH
H
: Acceleration/deceleration switching frequency 2
H
HH
H
: Acceleration time 4
H
HH
H
: Deceleration time 4
H
HH
H
: Acceleration/deceleration 4 pattern
H
HH
H
: Acceleration/deceleration switching frequency 3
• Function
Four acceleration times and four deceleration times can be specified individually. The selection/switching
mode can be selected from the following 3 options:
1) Selection by means of parameters
2) Switching by means of frequencies
3) Switching by means of terminals
[Parameter setting]
Title Function Adjustment range Default setting
H Acceleration time 2 [Note]~ sec. According to model
H Deceleration time 2 [Note]~ sec. According to model
H
Panel acceleration/deceleration
selection
:Acceleration/deceleration 1
: Acceleration/deceleration 2
: Acceleration/deceleration 3
: Acceleration/deceleration 4
H Acceleration time 3 [Note]~ sec. According to model
H Deceleration time 3 [Note]~ sec. According to model
H Acceleration time 4 [Note]~ sec. According to model
H Deceleration time 4 [Note]~ sec. According to model
Note: The minimum setting of acceleration and deceleration times have been set respectively at 0.1 sec. by default,
but they can be changed within a range of 0.01 sec. (setting range:0.01~600.0 sec.) by changing the setting
of the parameter V[R (default setting).
For details, refer to Section 5.20.
1) Selection using parameters
Time [s]
Output frequency [Hz]
FGE
FGEFGE
FGE
CEE
CEECEE
CEE
HJ
HJHJ
HJ
H
HH
H
H
HH
H
H
HH
H
H
HH
H
H
HH
H H
HH
H
0
Time [s]
Time [s]
Time [s]
H
=
H=
H
=
H
=
Acceleration/deceleration time 1 is initially set as the default. Acceleration/deceleration time 2, 3 and 4can be
selected by changing the setting of the H.
Enabled if EOQF= (operation panel input enabled).