Filter
Top Products
5-2 Safety Precautions Technobeam
®
User Manual
Safety Precautions
This section lists precautions you must follow anytime you are using
the Laser Aiming Device™ (LAD™) for Technobeam.
1. CAUTION: Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous
radiation exposure.
2. Using the Laser Aiming Device with any fixture other than Technobeam
may result in damage to both the laser and the fixture as well as
exposure to laser radiation.
3. Do not point the laser at an audience.
4. Precautions should be taken to ensure that the laser beam is not
unintentionally directed at mirror-like (specular) surfaces (most
importantly, at flat mirror-like surfaces).
5. Only qualified and trained employees approved by a laser safety
officer should be assigned to install, adjust and operate the laser
equipment.
6. When not in use, the laser (fixture) should be stored in a location where
unauthorized personnel cannot gain access.
7.
Do not remove
the labels shown at the bottom of this page; they are
required by U.S. and European safety agencies.
8. Areas in which this product is used should be posted with a standard
laser warning sign.
9. Do not stare directly into the beam and do not view the beam with
optical instruments.
10. The laser path should be located well above or below eye level.
11. The laser beam should be terminated at the end of its useful path.
12. Consult local and state laws regarding laser use and possible
registration requirements.
Laser aiming device assembly
(inside fixture)
LASER RADIATION - AVOID
DIRECT EYE EXPOSURE
Max output: 5mW at 630-650 nm
CLASS 3a LASER PRODUCT
Laser radiation is emitted from this aperture
AVOID EXPOSURE
Emission indicator
Max output: 5mW at 630-650 nm
CLASS 3a LASER PRODUCT
Cert. to EN 60825-1, 1994
and 21 CFR 1040
LASER RADIATION - DO NOT
STARE INTO BEAM OR
VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
DANGER