Filter
Top Products
Technobeam
®
User Manual Menu Options 3-11
Set Menu (SET)
The Set menu allows you to change the control method from a fixture
number to a DMX start channel or vice versa, and either set all factory
options to their default settings or change the factory options
individually. The procedures below are listed in the order that they
appear in the menu map.
Setting Factory Defaults (FACT)
Technobeam-i fixtures are shipped from the factory with the following
preset options set to the following defaults:
• Pan/tilt swap = off
• pan invert = off
• tilt invert = off
•preset playback = off
• LED display = on and bright
• LED display invert = off
• lamp hour warning = off
To return
all
preset options to their factory defaults settings:
5. Press and hold the <Menu> button until “ADDR” appears on the LED
display.
6. Using the <Up> and <Down> arrow buttons, scroll to the “SET” menu
and press the <Enter> button to select the “SET” menu.
7. Using the <Up> and <Down> arrow buttons, scroll to the “FACT” menu.
(This will be the first menu displayed.) Press the <Enter> button to
select the “FACT” menu.
8. Using the <Up> and <Down> arrow buttons, choose “ON” to set the
factory option defaults on and press the <Enter> button to select the
desired option.*
*Note
Although “OFF” is an available option in the FACT menu,
selecting the “OFF” option will have
no effect
on the
individual preset values. To change the value of any of
the individual presets listed above, you must access
each preset’s corresponding menu item. When you
change any of the preset default values individually, this
menu item will
automatically
be turned off.