Filter
Top Products
Technobeam
®
User Manual Installing the Yoke 1-9
2. Use a 1/4” allen wrench to attach one allen screw to each side of the
fixture (but do not fully tighten it), as shown in Figure 1-2.
Make sure
you place a yoke slide bezel between the yoke and each side of the
fixture.
Figure 1-2. Installing the yoke on the fixture.
3. Manually screw one T-handle into each side of the fixture. Do not fully
tighten the T-handles.
4. If you want to reposition the yoke, use a 1/4” allen wrench to loosen
the allen screws on the side handles shown in Figure 1-1 on page 1-8.
5. After loosening the side handle allen screws, slide the yoke to the
desired position. If you want to hang the fixture straight down, see the
section titled “Hanging the Fixture Straight Down” on page 2-12 now.
6. Make sure the yoke is even (i.e., the same distance from the rear of the
fixture on both sides).
7. Securely tighten the four side handle allen screws (two on each side).
8. Tilt the fixture to the desired angle, then securely tighten the other
allen screws and T-handle.