Filter
Top Products
6-20 Technobeam Laser Aiming Device™ Technobeam
®
User Manual
4. Only qualified and trained employees approved by a laser safety
officer should be assigned to install, adjust and operate the laser
equipment.
5. When not in use, the laser (fixture) should be stored in a location where
unauthorized personnel cannot gain access.
6. Do not stare directly into the beam and do not view the beam with
optical instruments.
7. The laser path should be located well above or below eye level.
The section titled “Safety Precautions” on page 5-2 has a complete
listing of safety precautions for using the Laser Aiming Device.
Live Components
You will be accessing live components and adjusting the laser in the
next section. Take special care to avoid contacting high-voltage live
components, located in the area of the main circuit board, shown in
Figure 6-24:
Figure 6-24. High-voltage component location.
When you activate the laser, observe the following precaution:
Caution Do not stare into the beam or view it directly
with optical instruments. Avoid accidental
exposure to laser radiation.
High voltage components
are located in main
circuit board